Torque pro track recordee user manual12/30/2022 ![]() Scroll/Load / Instant Doubles: Turn this knob to browse through lists and press it to select an item or load the currently selected track to the deck.The LEDs above the strip indicate the approximate location of the playhead in the track. Place your finger on a point along this sensor to jump to that point in the track. Search: The length of this strip represents the length of the entire track.Crossfader: Move this fader to mix between the decks.Deck Fader: Move this fader to adjust the volume level of the corresponding deck.To cue multiple channels simultaneously, press the Deck Cue buttons for both decks. Deck Cue: Press this button to send this deck’s pre-fader signal to the cue channel for monitoring. #Torque pro track recordee user manual softwarePull and hold this toggle toward you to activate the software effects momentarily, and release the toggle to deactivate the effects-the toggle will return to the center position. Pull the toggle back to the center position to deactivate the effects. Effects Toggle: Move this toggle switch away from you to activate the software effects-the toggle will latch to that position.Pressing the buttons will activate one effect at a time, or pressing and holding the buttons will activate multiple effects at once. FX 1–6: Press one of these buttons to activate or deactivate the corresponding software effect shown in the Serato software FX 1 and FX 2.Tap: Press this button multiple times at the desired tempo to manually set the BPM rate for beat-tempo effects, per channel.Beat: Turn this knob to set the Time Division for the selected effects.Depth: Turn this knob to adjust the “wet-dry” mix of the internal Flex FX on that deck.Booth: Turn this knob to adjust the output volume of the Booth Outs.The meters next to this knob indicate the audio signal level of the program mix. Main: Turn this knob to adjust the output volume of the program mix.Set it to the center (“12:00”) position to deactivate the filters. ![]() Turn the knob clockwise to apply a high-pass filter. Turn the knob counterclockwise to apply a low-pass filter.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |